Fabricated Jigs and Fixtures
  -----------------------------------
Cast Jigs and Fixtures
  -----------------------------------
Furnace Spares
  -----------------------------------
Wire Mesh, Expanded Mesh and Mesh Belts
  -----------------------------------
Investment Castings
  -----------------------------------
Heat resistant hardware
  -----------------------------------
Mild Steel and Stainless Steel Casting Division
  -----------------------------------
Scrap Recycling Program
  -----------------------------------
Chemical Composition
  -----------------------------------


   
 

Investment Castings

We offer investment castings in high Ni/Cr alloys. This process is capable of producing precise detail and dimensional accuracies in parts weighing from few grams to many kilo grams.

This process reduces and often eliminates need for machining. Our precise dimensional control allows castings to be used with little or no machining. Limitations in green sand moulding process of higher section thickness can also be overcome using this process. This not only reduces the casting cost, but also helps in reducing dead load on the furnace thereby increasing productivity.

It also saves on cost and time as it needs no welding assembling or finishing work. It produces surface finish that can not be obtained by machining or sanding. Design flexibility in Investment castings can not be found in other metal casting methods.

Typical uses of investment castings for heat treatment include Corner Posts, Loading Beams of thinner cross sections, Centre Pins, Cast links for Conveyors, Heating Element Holders, threaded Nuts, Washer type Spacers etc..